Pentair PENTEK INTELLIDRIVE PID10 Manuel D'installation Et D'utilisation page 16

Programming
Table 5 - Continued
Menu or
Parameter
Sub Menu
Excessive
Runtime
Detection
Ex Runtime
Excessive
Runtime Hours
Auto Restart
Delay
Number of
Resets
Detection Time
Dry Run
Sensitivity
Fill Time
Digital Input 1
Digital Input 2
I/O
Relay Output
Over Press Over Pressure
No Ground
No Ground
Detection
Reset Factory Reset
SW Update Software Update
Value
Unit of Measure
Default
_ Disabled
Hours 24
Minutes 10 Min
– 3
M:SS 15 Sec
PSI 10
M:SS 1 M
– Unused
– Unused
PSI 80 PSI
– Enabled
– No
– Disabled
Min Max
Enables or disables Excessive Runtime
Disabled Enabled
Detection.
Number of hours Drive can run before it
1 100
faults on Excessive Runtime.
Time Drive waits to restart pump when
3 Min 60 Min
Dry Run is detected.
Number of tries Drive attempts to restart
0 5 pump when Dry Run condition is
detected.
Time the Drive takes to recognize Dry
5 Sec 10 Min
Run condition.
Pressure value that Dry Run condition
is detected at. Dry Run fault will occur
0 300 if this pressure cannot be met within
Detection Time window. Lower pressure
= less sensitivity.
Time allowed to fill (prime) pipes during
Auto Line Fill process. Relates to Dry Run
15 S 10 M
Sensitivity value. (Time starts after 55 Hz
is reached).
Selects operation of Drive when terminal
I1 or I2 is used. Select between Unused,
Run Enabled, Ext Fault, and Setpoint. The
– –
Drive will respond to selected command
when voltage is present at I1 or I2
terminal.
Selects the operation of Drive when
terminal O1 is used. Select between
– –
Unused, Run, and Fault. The Drive closes
the Relay when Run or Fault is selected.
Sets Over Pressure Warning value.
15 PSI 97 PSI Change if higher than 80 PSI system
pressure is needed.
Selects whether Ground Detection
parameter is Enabled or Disabled. If
Disabled Enabled Disabled is selected, it will revert back to
Enabled after 72 hours. Warning LED will
flash entire time it is Disabled.
Resets all parameters to factory defaults.
Displays Setup Guide after it is complete.
No Yes
Software version displayed here. Does
not clear fault log.
Disabled Enabled Used to update software, if necessary.
16 16
Description
PN957 (3/23/20)