Citizen CT-S801 Type II Mode D'emploi page 62

b) Label paper
C
L
E
F
G
CAUTION
 Note the following points when using the auto cutter. Ignoring this information can
result in cutter lock or cutter malfunction.
• Make sure the paper cut length is at least 29 mm.
• Make sure the cut position is between labels. Cut the backing paper. Do not cut label
paper (tack paper).
 Always re-calibrate the paper sensor whenever you change the label backing paper
type.
 Make sure the left and right margins of the paper are at least 2 mm each.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
A
B
D
Cut position
Paper feeding
direction
Printable area
V10 CONSUMIBLES S.L.
M
Roll paper specifications
Label paper thickness (µm)
Label backing thickness (µm)
H I
Core inner diameter d (mm)
Core outer diameter D (mm)
Mark
A Label backing width
B Label width
J K
C Left edge of label
D Print width
E Top margin
F Print length
G Bottom margin
H Cut position between labels
I Gap between labels
J Label length
K Label pitch
L Left margin
M Right margin
— 58 —
Printable side
65 to 85
60 or less
25.4
32
(Unit: mm)
Item Dimensions
57 .5, 59.5, 79.5,
82.5 ± 0.5
(Size A) -4 ± 0.5
2 ± 0.5
(Size A) -8
2 ± 1
21 to 296
2 ± 1
1/2 x (Size I)
4 to 30
25 to 300
I + J
2 ± 1
2 ± 1