Statistics; Setting The Pellet Quality; Resetting Fuel Autonomy After Filling The Fuel Tank - Austro Flamm Ben Manuel D'instructions

!
NOTE: Ben, Polly light and Percy light do not have a tilting grate. This means that you can only
use the ""Week timer" to a limited extent. Once ash cake covers the base of the burner bowl above
the ignition hole, it is no longer possible to carry out automatic ignition. This means that you must
empty the burner bowl in good time to be able to start your pellet stove reliably using the timer
function. With models that do not have a tilting grate, we recommend setting a maximum of one
timer per day.

4.8. Statistics

To view the statistical data of your pellet stove, proceed as follows:
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
 
Select the desired period.

4.9. Setting the pellet quality

You can set three different pellet qualities.
Fuel quality 1 is a very high quality. Fuel quality 3 is a very low quality (a high proportion of softwood,
dusty, low calorific value). The default "Fuel" setting is fuel quality 2.
To select the fuel quality, proceed as follows:
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
 
Set the desired fuel quality by tapping the
changes immediately.
10.4. Activating monitoring of fuel autonomy
The pellet stove's controller can calculate how long the amount of pellets in the stove can last for. You
can read this off the control panel. This option must be activated first.
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
 
-

4.10. Resetting fuel autonomy after filling the fuel tank

After you have filled the pellet tank, you must reset fuel autonomy.
To reset fuel autonomy, proceed as follows:
71

 
''Fuel''
 
"Fuel"
and/or symbols. The system saves the
 
"Fuel autonomy"
english
"ON".