Austro Flamm Ben Manuel D'instructions page 72

english
Table 15 - Correct use of the week timer (example)
To set the week timer, proceed as follows:
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
 
-
Select the day(s) of the time interval that you want to display by tapping the appropriate
abbreviation (Mon = Monday, Tue = Tuesday, Wed = Wednesday, Thu = Thursday, Fri = Friday,
Sat = Saturday, Sun = Sunday).
Set the start time (hours and minutes) by tapping "Start time'' and then the
symbols. Tap ''OK'' to save your settings.
Set the end time (hours and minutes) by tapping "End time'' and then the
symbols. Tap ''OK'' to save your settings. Tap
Set the target temperature by tapping the
settings. If you change your mind, tap on "Delete" and the time interval is not saved.
To activate the set week timer, tap "ON" at the top right in the Timer menu. To deactivate the set
week timer, tap "OFF" in the Timer menu.
Tap to exit the Timer menu.
!
NOTE: If the currently measured temperature is higher than the set target temperature, the
system does not switch on the pellet stove until the temperature has dropped below the
target value.
70
 
''Add new timer''
to get to the temperature.
symbols. Tap ''Save'' or  to save your
and/or
and/or
and/or