Switching On The Pellet Stove; On Thecontrol Panel; Changing/Selecting The Power Level - Austro Flamm Ben Manuel D'instructions

english
4.5. Sw itching on the pellet stove
4. 5. 1 . O n th e cont ro l p an el
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
Keep pressed (see below):
The system displays the following screens:
4. 5. 2 . Vi a inf r a re d re mot e c ont r ol ( if p re s ent )
As-standard, models Polly 2.0 and Percy are fitted with an infrared remote control; this is available as an
accessory for the Polly light and Percy light models.
Make sure that you there is an unobstructed line of sight between the remote control and the control
panel.
4.6. Changing/selecting the pow er level
On the control panel, you can set five different power levels.
ON/OFF
ON/OFF
Output +
Power UP
Output -
Power DOWN
IR remote control unit
Figure 10: Infrared remote control (description of buttons)
Figure 11: Infrared remote control (operating angle)
68
IDLE DISPLAY MODE
Target temperature +
Desired temperature UP
Target temperature -
Desired temperature DOWN
7m
30°
30°
6m
30°
30°
6m
90°
90°
90°