Enhanced Display; Sleep Mode; Thermal Rollback; Battery Condition Meter - Quantum Rehab Q-Logic 2 Instructions De Fonctionnement

20

Enhanced Display

The Enhanced Display module is primarily used with specialty control
devices like a head array. It also can be used to provide a graphical
display for the Stand-alone Joystick. When used with the hand control,
it provides a larger display than the hand control's LCD. The Enhanced
Display is mainly used in more advanced applications. Contact your
Quantum Rehab Provider for more information.
The Enhanced Display has the following controls:
On/Off Button
Enables/disables power
On/Off and Mode Jacks
Allow for remote On/Off and Mode switch installations
9-pin D-sub Connector
Allows for connection of a specialty control device
LCD Screen
A color LCD display that may be equipped with built-in infrared
(IR) for remote control and with Bluetooth mouse control

SLEEP MODE

The Q-Logic 2 Controller offers a sleep mode feature that will shut off
the main power if the joystick remains stationary for a programmed
period of time from 0 to 240 minutes. To restore power and resume
operation of the chair, push the On/Off and Mode Select Lever up once.
A set time of 0 minutes disables the sleep mode feature.

THERMAL ROLLBACK

The Q-Logic 2 Controller is equipped with a thermal rollback circuit
that monitors the temperature of the chair's motors and controller. If
either exceeds the safe operating temperature, the controller reduces the
output to 20% of full operation level. This reduces the chair's speed and
allows a cool-down period. Once the temperature returns to a safe level,
the chair will resume normal operation.

BATTERY CONDITION METER

The battery condition meter is located in front of the joystick on the
hand control and as an LED on the Attendant Control and Stand-alone
Joystick.