Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10
OPERATING THE Q-LOGIC 2 CONTROLLER
The Q-Logic 2 hand control is used to operate your power chair and all
of its components.
On/Off and Mode Select Lever
The On/Off and Mode Select lever turns the system on and off and is also
used to select drive profiles.
WARNING! Unless faced with an emergency situation, do
not use the on/off lever to stop the chair. This will cause
the power chair to stop abruptly.
WARNING! Always turn the power off when you are
stationary to prevent unexpected movement.
Joystick
The joystick controls the driving speed and direction of the power chair.
When the joystick is at rest, it is in the neutral (center) position and the
chair is stationary. In order to drive the chair, the joystick must be taken out
of neutral. Moving the joystick in any direction will switch the chair from
neutral to drive, and the chair will move in the direction indicated by the
joystick position. The farther away from the neutral position the joystick
is, the faster the chair will move in that direction. To stop chair movement,
simply release the joystick or move it back to the neutral position. The
chair's electromagnetic brakes will engage after the chair has come to a
controlled stop.
Lock/Unlock Procedure
The Q-Logic 2 Controller comes with a programmable lock/unlock option.
NOTE: The lock-out feature is not programmed at the factory. To have
this feature added, contact your Quantum Rehab Provider.
To lock the controller:
1. Power the controller on.
2. Push and hold the On/Off and Mode Select Lever in the on position
until the controller turns off. The controller is now locked.
To unlock the controller:
1. Turn the controller on. The words "System Lock" will appear on the
display screen.
2. Move the joystick to the full forward position until you hear a beep.
3. Move the joystick to the full reverse position until you hear a beep.
4. Release the joystick. The controller is now unlocked.
Publicité
Chapitres
Table des Matières
