Auxiliary (Aux) Menu; Standby Select Menu; Attendant Control/Stand-Alone Joystick - Quantum Rehab Q-Logic 2 Instructions De Fonctionnement

Auxiliary (Aux) Menu

The Aux Menu screen displays the auxiliary operations that are
available when operating in the Aux profile. In a standard basic system
with only a hand control and a power module, typically there is no Aux
profile. In more complex systems, an Aux profile provides access to the
operations made possible by the additional modules. Contact your
Quantum Rehab Provider for more information.
Aux Menu
Quick Access List
Aux Modes
System
Figure 3. Aux Menu Screen

Standby Select Menu

The Standby Select Menu screen appears after the programmed timeout
when Standby Select is enabled. Standby Select allows the user to
navigate through the available profiles without the use of a Mode key.
The profile that was active when the timeout occurred is highlighted.
Contact your Quantum Rehab Provider for more information.
Attendant Control and Stand-alone Joystick
For more information on these applications, contact your Quantum
Rehab Provider.
The Attendant Control and the Stand-alone Joystick are similarly laid
out:
On/Off Button
Enables/disables power
Actuator LEDs
Indicates actuators in use
Joystick
The joystick controls speed and direction in Drive mode.
Push the joystick to the right to select actuators in Seat mode.
Move the joystick forward or backward to activate the desired
actuator(s).
On/Off and Mode Jacks
Allow for remote On/Off and Mode switch installations
Standby Select
Drive 1
Drive 2
Drive 3
Seat
Aux Menu
Figure 4. Standby Select Menu
Screen
Battery Condition Meter
Indicates battery charge
Mode LED
Used for profile selection
19