Lcd Screen; Drive Screen - Quantum Rehab Q-Logic 2 Instructions De Fonctionnement

12
Left/Right Turn Indicator Buttons
The left/right turn indicator buttons toggle either the left or right turn
indicators.
To operate the turn indicators:
1. Push the On/Off and Mode Select Lever up once to power on the
chair and the controller.
2. Press the desired turn indicator button once to turn on that indicator.
3. Press the same turn indicator button again to turn off that indicator.
NOTE: If the left turn indicator is activated, pressing the right
indicator button will turn off the left indicator and activate the right
indicator.
NOTE: The turn indicator buttons also control the hazard lights.
Press both turn indicator buttons at the same time to activate the
hazard lights and press both buttons again to turn off the hazard
lights. If the hazard lights are left on and the controller is turned off,
the hazard lights will continue to flash. The Q-Logic 2 must be turned
back on and both turn indicator buttons must be pressed to deactivate
the hazard lights.

LCD Screen

The Q-Logic 2 provides the user with easily intuited feedback
information via the LCD screen. The circle at the bottom middle of the
screen represent a stoplight. A green light indicates full drive operation,
an amber light indicates limited drive operation, and a red light indicates
that drive operation is prohibited.

Drive Screen

The LCD provides the current time in either 12- or 24-hour clock
format, the current profile, drive operation, the speed adjustment
setting, the trip odometer, and the overall odometer reading.
Drive/Function Inhibit status is depicted as a green light in lower center
of the screen. Actuator adjustment will affect the inhibit status. As your
seat and/or back angle increases, a red light will indicate full drive
lockout. If your power chair is equipped with a seat lift, a yellow light
will indicate speed reduction as the seat is elevated. To return your
power chair to green status, reverse operation.