Publicité
Les langues disponibles
Les langues disponibles
Sabre saw comes to a stop
during cutting
Centre pin shears off, saw
blade cannot be adequately
clamped
Sabre saw runs slower during
cutting
Other problems
We ask you to send the machine to the manufacturer, if necessary.
To guarantee the performance of the machine it is necessary to compensate the
pressure under water. For every 10 meters of depth it is necessary to add one bar
pressure to the compressor with respect to the indicated.
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims
in regards to persons or equipment damages are invalid, if one or more of the following causes
apply:
•
Improper use of the machine,
•
improper assembly, startup, operation or maintenance of the machine,
•
operation of the machine with defect safety devices or improperly fixed or non•functioning
safety and protection devices,
•
not considering of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine,
independent structural alterations or settings on the machine beyond the intended purpose,
•
inadequate supervision of wear parts,
•
improperly carried out repairs, inspections or maintenance,
•
catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our
control.
Feeding pressure too high
Blunt saw blade Unsuitable
saw blade
Clamp screw worn/
hexagonal socket wrench
worn
Compressed air is not
lubricated – dry run
WARRANTY AND LIABILITY
Reduce feeding pressure
Replace saw blade (new)
Replace saw blade
(appropriate for the cut)
Increase operating pressure to
6 bar
Replace clamp screw/
hexagonal socket wrench
Fill the line oiler with oil.
Check oiler setting
(approximately 2•5 drops per
m³/min air consumption)
Contact authorized expert
company
51
Publicité
