Publicité
Les langues disponibles
Les langues disponibles
•
are proved and specified to be non•conductive when being used next to electric conductors.
Always use hoses, lubricating oil and antifreeze lubricants, which meet the local safety
requirements for use in areas exposed to explosion hazards.
Connecting the air supply to the pneumatic sabre saw
Remove the locking cap from the air connection 3 (see fig. 2). Connect the pneumatic hose
(not contained in the scope of delivery.
Air inlet
The size of the saw blade depend on the material of the work piece (refer to accessories).
During cutting, the saw blade has to be cooled, respectively lubricated, with water, drilling
emulsion, oil or cutting paste.
Mounting the saw blade
WARNING – Disconnect the machine from pneumatic supply before mounting
the saw blade.
Observe the following for mounting the required saw blade to the saw:
•
Loosen socket head screw item A (see fig. 3),
•
insert the saw blade item C to its stop,
•
securely tighten the socket head screw item A (see fig. 4).
Fig. 2
STARTUP
Fig. 3
Exhaust (sound absorber)
Fig. 4
37
Publicité
