Publicité
Les langues disponibles
Les langues disponibles
Assembly Accessories - Figure B
Squeegee
• Insert the squeegee into the front of the
appliance as show in Figure B.
• Make sure the accessory is fully pushed in.
B
Charging the battery
From new, the rechargeable cells of the
product need a minimum charge time of 16
hours to ensure full power.
• The switch must be in the off ("O")
position, the product will not charge if it is
in any other position.
• Figure C - Plug the jack plug of the
charger into the charging socket of the
tool. Plug the charger into any standard
120 Volt 60 Hz electrical outlet.
While charging, the charger may get
warm, this is perfectly normal and safe. It
is safe to leave the appliance connected
to the charger indefinitely. The charger
automatically reduces power consumption
when charging is complete.
WARNING:
battery at ambient temperatures below 50
°F or above 104 °F.
C
Switching On - Figure D
• Figure D - To start, slide the On/Off switch
forward (i.e. "O"= Off, "I" = On).
• To stop, slide the switch back.
• Return the product to the charger
immediately after use so that it will be
ready and fully charged for the next use.
Plug the jack plug of the charger fully into
the charging socket of the vacuum.
Do not charge the
D
Dry pick up
• For everyday spills of dry material.
• Do not fill the dust bowl (3) beyond the
end of the intake chute.
Wet and dry pick up
• For everyday spills of dry material, use
your appliance without the squeegee
accessory.
CAUTION: Your product is designed for
light spills only.
• This vacuum can also be used to pick up
everyday liquid spills. Use the squeegee
accessory on non-absorbent, hard
surfaces. On absorbent surfaces, such
as carpet, your appliance will pick up wet
spills better without the accessory.
• For best performance on hard surface wet
pickups, insert squeegee into the bowl
nozzle opening.
• For best results when using this
accessory, hold the appliance at an angle
of 45° and pull it slowly towards you.
• Do not fill the bowl beyond the end of the
intake chute. If there is any liquid in the
bowl, do not turn the unit upside down,
sideways, point the nozzle upward, or
shake the vac excessively.
• After picking up liquid substances clean
the vac and filter immediately. Mold and
mildew may form if the unit is not properly
cleaned after wet pickups.
• If charging in a vertical position, be sure to
empty all liquid contents to avoid damage
to your appliance.
Optimizing the suction force
In order to keep the suction force optimized,
the filter must be cleaned regularly during use.
EMPTYING AND CLEANING
THE PRODUCT.
WARNING:
without its filter.
NOTE: The filter and foam insert are reusable,
do not confuse them with a disposable dust
bag, and do not throw them away when the
product is emptied. We recommend that you
4
Never use the vac
Publicité
