Bosch OS50VC Consignes D'utilisation/De Sécurité page 9

2610051954.qxp_OS50VC 8/16/18 12:47 PM Page 9
Notes:
• Make sure that SheetLoc™ System's front
clamp lever is latched, even when PSA
abrasive sheets are used.
• Remove PSA sheets soon after completing
each sanding operation in order to prevent
the adhesive from creating a hardened
bond with the backing pad.
REMOVING PSA ABRASIVE SHEETS
from pad will likely damage the backing pad.
If PSA paper is accidentally left on the pad,
sand for a few minutes to soften the adhesive
backing, then lift an edge of the PSA sheets
with your fingernail and peel it off the backing
pad.
PUNCH PLATE
After the paper has been installed, it will be
necessary to punch holes into the paper using
the punch plate provided with your sander.
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
empty it frequently after completion of
sanding and before storing the sander. Be
extremely careful of dust disposal, materials in
fine particle form may be explosive. Do not
throw sanding dust on an open fire.
FIG. 7
Attempting to remove a
cold PSA sanding sheet
Dust Collection
Your tool is equipped
with a dust canister;
DUST
CANISTER
Align sander base with punch plate and push
down on sander until punch plate pierces the
paper. Then remove punch plate from sander
(Fig. 6).
FIG. 6
D
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with dust
particles can occur if there is a static
discharge, spark introduced in the box, or
excessive heat.
REMOVING AND INSTALLING
DUST CANISTER
To remove dust canister: Twist the dust
canister and simply pull away from the tool
(Fig. 7).
To install dust canister: align dust port with
hole in canister and push canister onto tool
until it locks into place (Fig. 8).
I
FIG. 8
DUST
CANISTER
-9-
PUNCH
PLATE
DUST PORT