dB Technologies Moving D Caractéristiques Techniques page 31

3.6.3 MENU 3 - PARAMETERS B
Menu 3 displays the type of transmitter and its microphone capsule. This information is automatically recognized
by the receiver when it is RF connected with the transmitter.
From this menu, you can set encryption in the transmission that can only be decoded by the associated receiver.
Finally, it is possible to select the power of the transmission signal (RF Power).
ENCRYPTING
With this selection, you can introduce encryption in the transmission that can only be decoded by the associated
receiver.
•
Select Encrypt and change the setting from NO to YES, then confirm.
•
Create the Keygen encryption string and press OK;
•
Follow the data writing procedure in paragraph 3.6.1 to configure the transmitter.
In this state, only the receiver that has the encryption key stored is able to reproduce the audio received from the
associated transmitter. The symbol of a key will appear on the initial screen of the display.
If you want another receiver to decode the signal of an encrypted transmitter, read the information indicated in
paragraph 3.6.1.
Any other receiver that receives the signal will not be able to reproduce it, an exclamation point (!) will appear on
the display instead of the key to indicate this anomaly.
To deactivate signal encryption, change the parameter in the receiver settings and then reprogram the
transmitter.
Note. Once encryption is activated and the transmitter is programmed, the associated receiver will continue to
reproduce the signal regardless if the Encrypt parameter is activated on the receiver or not, the key symbol that
appears on the display represents the programming status of the transmitter.
ERP OUTPUT POWER (RF Output Power)
The Moving D receiver output signal power (RF Power) is factory set to 10mW, in line with the requirements set
out by all the countries where it is designed to be used.
The output signal power may be raised to 50mW, but the change must only be performed after
verifying with the local Authority of the country of use that it complies with the applicable
regulations.
•
Select "RF Power" and turn the knob (4) to select the desired value, press the knob to confirm.
•
Follow the data writing procedure in paragraph 3.6.1 to configure the transmitter.
3.6.4 MENU 4 - OUTPUT LEVEL
This is used to set the volume of the audio signal output in dB and displays the status of the level button located
on the rear of the receiver Mic / Line.
•
Turn the knob (4) to select the desired value , press the knob to confirm.
NOISE GATE SETTINGS
•
By turning knob (4), select the Noise Gate triggering threshold value, then press the knob to confirm.
The threshold value must be set from 1 to 100, where 1 is the low level and 100 is the maximum; select OFF to
disable the function.
ENGLISH
30