dB Technologies Moving D Caractéristiques Techniques page 27

2.3 REAR PANEL FUNCTIONS
9) Power connector "Power 15Vdc-1A"
The socket provides power to the receiver through the supplied 12-15Vdc power supply. Use only the
provided power supply.
10) Connector "Line Out Unbal"
Mono Jack 6,3mm connector for audio level output (unbalanced).
11) Connector "Mic Out Bal"
XLR connector for balanced output.
12) Switch "Mic/Line"
This control allows to select the level of the output signal MIC / LINE.
13) ANTENNAS "A" and "B"
Two BNC connectors for antennas or antenna splitter cables connection.
14) Connector "HUB Bus"
RJ11 connector for HUB 800 (optional) device connection, which allows the remote control.
15) Connector "USB"
USB Mini-B connector allows connection to a PC where it should be installed the dedicate software,
available on website www.dbtechnologies.com.
16) Cable lock/anti-tampering
Used to lock the power supply cable and prevent accidental tampering with the cable itself.
3 RECEIVER OPERATION MOVING D-R
The receiver must be supplied with power using the provided power supply unit exclusively.
3.1 BASE CONNECTIONS
Connect and lock the two supplied antennas (or the optional antennas MOVING D-ANT) into their BNC inputs of
receiver and position the antennas so that there are an 90° angle between them (see picture below).
Connect the power supply unit to the "Power 15Vdc - 1A" socket on the back of receiver.
ENGLISH
26