Bosch GBH18V-36C Consignes D'utilisation page 12

160992A536_GBH18V-36C 2/19/20 1:51 PM Page 12
Connectivity Module
Installation (sold separately)
operating instructions included with
Bosch connectivity module. Operating
instructions for connectivity module
include important information not
covered in this manual.
If connectivity module is not purchased
with the tool, or if the replacement of
the module or the battery becomes
necessary, please follow this procedure
(See Fig. 6):
- Using a flat screwdriver or a coin,
remove the cover A from the side of
the handle, by turning it 1/8 turn
counter-clockwise (Fig. 6 or 7).
- If the tool is already equipped with
the connectivity module, remove the
battery B, but do not remove the
connectivity module C.
- If the connectivity module is installed
for the first time, remove the plastic
placeholder D from the connectivity
module compartment, and place the
connectivity module C in the
compartment observing correct
orientation (Fig. 7). Note: Store the
placeholder D in a safe place.
Reinsert the placeholder again if the
communications module is removed.
- Next place new battery B on the top
of the connectivity module with the
"+" polarity facing up (Fig. 6).
accessories. Such preventive safety measures reduce the risk of starting the tool
accidentally.
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable
speed trigger switch 8. The tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. The speed can be
adjusted from the minimum to maximum
nameplate RPM by the pressure you
apply to the trigger.
Assembly
To reduce the risk of
injury read
Operating Instructions
Disconnect battery pack from tool or place the switch in the locked
off position before making any assembly, adjustments or changing
Apply more
Fig. 6
the
Fig. 7
- Place the cover A over the battery
and turn it ⅛-turn clockwise to lock
using a flat screwdriver or a coin.
pressure to increase the speed and
release pressure to decrease speed
(Fig. 8).
discontinue use of the tool if the
variable speed control ceases to
function. Subsequent loss of on/off
control of the trigger switch is likely.
-12-
A
B
C
A
D
To reduce the risk of
injury immediately