Use; Unpacking; Assembling The Caddy; Immersing The Cleaner - Zodiac VORTEX 3 Notice De Montage Et D'utilisation

2-Notice CO ANG.qxd 13/09/10

3.1. UNPACKING

The packaging should contain the following items:
•
The robot, a transport caddy, a control unit, a user manual, and
a remote control unit (Vortex
Proceed as follows to unpack these items:
•
Remove the bag containing the caddy parts.
•
Remove the box located on the cleaner: it contains the control box.
•
Remove the 2 top caddy tubes.
•
Remove the lower part of the caddy.
•
Remove the cleaner.
Check that the appliance has not been damaged during transport
(shocks, broken parts, etc.). If you notice any defective parts, please
contact your retailer immediately and before using the cleaner.

3.2. ASSEMBLING THE CADDY

3
4
Diagram 2
5
6
8
Diagram 3

3.3. IMMERSING THE CLEANER

Do not allow bathing when the cleaner is in the pool.
Immerse the cleaner in the water
(Diagram
it slightly in all directions (4-2) so
that the air in the robot is expelled.
9:12 Page 16
TM
a) Insert the top tubes (1) and (2) into the lower part of the caddy.
9 The tubes should be oriented towards the cable holder as shown
8
in diagram
7
b) Fit the cable holder (3) and its cover (4) on the lower part of
the caddy.
c) Fit the screw (7) at the bottom of the cable holder and tighten
it using the key.
d) Fit 2 long screws (8), into the holder cover while maintaining the
nuts (9) in the cable holder and tighten them.
e) Fit the cable holder (5) and its cover (6), place the screw (7) on
9
the top part of the cable holder and tighten it using the key.
f) Fit the long screws (8), in the control box holder (6) while
maintaining the nuts (9) in the cable holder and tighten them.
4-1) vertically and move

3 / USE

4 robot only).
1.
16
1
6
5
7
8
9 3
4
10
Diagram 1
Diagram 4
2