THOMSON VS 990 Manuel D'utilisation page 8

01_VS990_en 15/11/05
Relay of pictures from several
units
If you have several equipment items (VCR
player, satellite receiver, DVD player, etc.) in
your main equipment room and want to
transmit and receive audio and video
signals to a second TV set, connect your
equipment items as shown in the Diagrams
(on the transmitter side) on the separate
document or at the end of this booklet.
Usually, the units are connected in series.
These diagrams represent some connection
possibilities the operation of which depends on
the type of unit, its sockets and the signals it
produces. There may be other connections that
you might wish to try if the diagrams given here
1
TV1
AV1
VCR
DVD
SAT
VS 990 / EN - SD / epheme - rst / 11-2005
17:57 Page 4
All manuals and user guides at all-guides.com
Transmitter
AV1
AV2
2
AV2
Transmitter
are not satisfactory. If this is the case, please ask
your dealer for assistance.
As a general rule, remember to switch off units
not in use. Also, refer to the manufacturers'
instructions to see if there are any particularities
regarding connection or use. Certain units may
need to have their input scart connection
"programmed".
In all cases the transmitter must be connected to
a scart connection that produces an Audio-Video
signal Out. Refer to the manufacturer's
instructions for confirmation of this.
It is essential that you switch off all unused
equipment (put them on standby).
TV1
VCR
Decoder Sat/Cable
(Canal+, Canal Sat,TPS, Premiere,Telepiu,Via Digital...)
3
AUDIO
Ampli Audio
4
Transmitter
AV Out
VCR
DVD
SAT