Calling Up Configuration Mode; Setting Time And Date; Entering Longitude And Latitude - eQ-3 WS300 Notice D'emploi

IN
>2 seconds
+
-
NEXT
+
-
NEXT
+ -
NEXT
+
-
NEXT
+
-
NEXT
44

Calling up configuration mode

Press key „IN" for approx. 2 seconds. When the key has been
released, the corresponding display appears.
You can leave the configuration mode at any time by pressing
„EXIT" (= „SENSOR"), see „Terminating configuration
mode".

Setting time and date

Set current year using the keys „+" and „-".
year
Press „NEXT" key.
Set current month using the keys „+" and „-".
month
Press „NEXT" key.
Set current day using the keys „+" and „-".
day
Press „NEXT" key.
Set minutes using the keys „+" and „-".
minutes
Press „NEXT" key.
hours Set hours using the keys „+" and „-".
Press key „NEXT"; then you can set the latitude („LA" appears
on the display).
Entering latitude/longitude
It is necessary to state the location of the weather station in
order to calculate the sunset/sunrise times.
You can enter the latitude at a range of between -60.0° to +60.0°.
The manufacturer's setting is Berlin. You can determine your
position in different ways:
• in chapter 18 on page 61, you will find a table with the co-
ordinates of several German cities. Select a nearby location
near and enter its coordinates.
• if you have a GPS navigation device, e.g. in your car or a
mobile device, you can adopt its position details and thus
the exact position.
• you can also obtain the exact co-ordinates in the Internet.
There are numerous sites that deal with navigation.
Please observe the fact that the information concerning the
sunrise / sunset would only be correct to be exact at the sea
of for completely level landscape. Mountains, high forests etc.
will alter these values for your location.
Even for the ideal situation, the information can deviate by
some minutes as an approximation formula is used for the
calculation.