Jet JTSS-1700 Mode D'emploi page 4

4.4 Content of delivery
Sliding table
Crosscut table (JTSS-2500/3200)
Crosscut fence (JTSS-2500/3200)
Miter fence (JTSS-1700)
Rear extension table
Right extension table
Rip fence with dual fence profile
Rip fence support rail
Saw guard
Sawblade 315mm
Scoring blade 80mm
Back stop
Dust connection hose and Y-adapter
Push stick
Operating tools
Assembly bag
Operating manual
Spare parts list
5. Transport and start up
5.1 Transport and installation
The machine will be delivered on a
crate.
Attention:
Do not remove the motor transport
lock before the machine has been set
in place.
Do not operate the handwheels.
Use a forklift or lifting straps to lift the
machine off the pallet (Fig 1).
Fig 1
Warning:
The machine weight is heavy
JTSS-1700....410kg
JTSS-2500....520kg
JTSS-3200....610 kg
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
For transport to the desired location
use a forklift or hand trolley. Make
sure the machine does not tip or fall
off during transport.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
The machine must be levelled in both
directions to assure good sliding
motion of the sliding table.
If possible, the machine must be
placed on rubber plates which act as
shock absorbers and reduce the noise
level.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Romove the motor transport lock
The two blade adjusting handwheels
may not be operated until the
transport lock is removed.
Remove the cabinet side cover.
Remove the 2 hex socket bolts (1).
Remove the motor leg screw (3).
4
Remove the red coloured motor
transport lock (2).
Reattach the motor leg screw (3).
Reattach the cabinet cover.
The handwheels can now be operated.
Mounting Rear Extension Table
Attach rear extension table to the
machine table and put surfaces in
level with help of screws (U).
Fig 2
Mounting Right Extension Table
Attach right extension table to the
machine table and put surfaces in
level.
Fig 3
The right table extension of JTSS-
3200 has an adjustable support leg
(V).
Mounting rip fence base rail
Mount the rip fence base rail (Y) to the
front of the saw table and right table
extension.