Installation And Connection - Bartscher 700.271 Mode D'emploi

•
Do not keep heavy, poisonous or rusty objects in the refrigerator.
•
Take caution not to damage any part of the cooling system (compressor, etc.) to
avoid a coolant leak.
WARNING!
If coolant does leak from the cooling system, remove the device's plug from the
power source and call the customer service centre.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label). Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

NOTE!
At least two people are needed to set up the device!
•
Discard the complete packing material after unpacking the device.
•
The refrigerator is transported on a styrofoam base. Remove the tape from the sides of
the base, then pick the refrigerator up and remove the styrofoam base.
•
Take the handles (1) out of the bag and insert them
into the proper place (2) at the back of the device
(Fig. 5).
•
Remove the tape and open the door. Remove the
separators over the doors. Tilt the refrigerator
backwards, then adjust the front supports to the
desired height so that the door closes itself. To
adjust the supports, it is necessary to lift up the
refrigerator a bit at the front, so that the front
supports do not touch the floor.
•
Place the device on top of an even and safe surface which supports the weight of the
device.
•
Not at any time should you place the device on an inflammable surface (such as:
carpet).
•
Do not place the device near the open fire sources, electric ovens, heating stoves or
other heat sources, for example direct sunlight. Exposition to high temperatures may
cause damage to the device surface or may negatively influence cooling power and
energy consumption.
- 30 -
Fig. 5