Installation And Connection - Bartscher 700.455 Mode D'emploi

WARNING! Hazard via electrical current!
Avoid contact between the device and water. Do not allow the water to be affected
by rain, dripping water or other forms of moisture. This may lead to damage to the
device or electric shock.
•
Do not keep heavy, poisonous or rusty objects in the refrigerator.
•
Take caution not to damage any part of the cooling system (compressor, etc.) to
avoid a coolant leak.
WARNING!
If coolant does leak from the cooling system, remove the device's plug from the
power source and call the customer service centre.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

ATTENTION!
Installation and maintenance operations may only be performed by qualified
professionals!
•
Unpack the device and remove packaging.
•
Leave the device on its pallet.
•
Raise the refrigerator using a pallet jack and place it where it is intended to be located.
•
Do not push or pull the refrigerator as it may tilt, causing damage to the external
casing and adjustable legs.
•
When the refrigerator is placed in its intended location, remove the pallet. Take care
not to hit the device.
•
Place the device in a flat, secure place that will support its weight.
•
Set up the device using the adjustable legs. Use a level as needed. Every leg must
touch the floor, as otherwise the door may open and close improperly.
- 28 -