Zephyr Essentials Ravenna ZRV-E30AGC Guide D'utilisation, D'entretien Et D'installation page 15

SURFACE MAINTENANCE:
Clean the hood surface periodically with hot soapy water and clean cotton cloth. Do not use corrosive or
abrasive detergent, or steel wool/scouring pads which will scratch and damage surface.
For heavier soil use liquid degreaser.
After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners, to polish and
buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
Do not use any product containing chlorine bleach. Do not use "orange" cleaners.
Aluminum Mesh Filters
The aluminum mesh fi lters installed by the factory are intended to fi lter out residue and grease from
cooking. They need not be replaced on a regular basis but are required to be kept clean.
Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if
heavily soiled.
Dry fi lters and re-install before using hood.
Removing Aluminum Mesh Filters
1. Pull down on fi lter latch to release fi lter tabs
2. Pull down on front of fi lter to remove
Should fi lters wear out due to age and prolonged use,
replace with following part number:
Hood Model:
ZRV-E30AG / ZRV-M90AG
Part No. Qty to Order
50200044 1
13