Ecler CA200z Notice D'utilisation page 16

To enter the MIC SETUP MODE, first select zone A or B with a tap of the front knob or
the IR remote (only when using the ZONES mode), then press MIC1 or MIC2 key and
Front knob SP : Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP : Long Press (press & hold the front panel knob for more than 2.5 seconds)
Default mode (STEREO / MONO / BRIDGE / ZONE A or ZONE B)
MICx setup mode
(x = 1, 2, 3 or 4)
Rotate knob
to browse
options
The following graphic shows the ADVANCED adjusting procedure for the MIC1 and
MIC2 inputs (a special key combination is required for access):
16
Front panel MIC sources setup
hold it for more than 2.5 seconds
MIC1 or MIC2
SP
VOL
Rotate knob
to browse
options
BASS
Rotate knob
to browse
options
TREBLE
Rotate knob
to browse
options
ADVANCED MODE
KEY CODE REQUIRED
Press & hold MICx key
to enter MICx setup mode
LP to enter
LP
the VOLUME
adjust mode
SP to get
SP
back
LP to enter
LP
the BASS
adjust mode
SP to get
SP
back
LP to enter
LP
the TREBLE
adjust mode
SP to get
SP
back
MIC1 MIC2
Press and hold MIC1 + MIC2 +
LP
+ + front panel knob to enter the
MIC SETUP ADVANCED MODE
Rotate knob
Level
to adjust
shown in
level
LCD
MICx VOLUME
Level: 0 to 64
Rotate knob
Level
to adjust
shown in
level
LCD
MICx BASS
Level: -10 to +10
Rotate knob
Level
to adjust
shown in
level
LCD
MICx TREBLE
Level: -10 to +10