Dell PowerVault 220S Guide D'installation page 15

F i g u r e 1 - 7 . R e m o v i n g t h e F r o n t B e z e l
lock
bezel
Label all hard drives and remove them from the system.
3
NOTE: Although it is not necessary for the conversion, you might want to remove the two
power-supply and cooling modules at the back of the system chassis to reduce the weight of
the chassis while you are performing this procedure (see your system Installation and
Troubleshooting Guide for instructions for removing and replacing these modules).
To remove the system left and right covers (see Figure 1-8):
4
Remove the two round covers from the top of the tower system.
a
Use a 3/16-inch hex-head (Allen) wrench to remove the hex-socket cap screws and
b
flat washers from the top of the tower system.
Slide the left and right cover back, away from the chassis front to disengage, and
c
pull the covers up, away from the base to remove.
thumbscrew
Ra c k In s ta l la ti on Gu i d e
1-11