Zibro Kamin KRA 106 Manuel D'utilisation page 62

9 9
1 1 0 0 b b
1 1 1 1 b b
8mm
NOTE: Make certain the top of the wick adjuster and
the top of primary air tube are the same weight. If they
uneven, the flames tend to be uneven, too.
9 Tighten the four (4) wing nuts around the wick
adjuster.
1 1 0 0 a a
10 Engage the automatic extinguisher by turning the
safety button clockwise into vertical position. Turn the
wick adjuster knob to be sure the wick moves smoothly
up and down.
AFTER REPLACING THE WICK, CHECK THE OPERATION
1 1 1 1 a a
OF THE AUTOMATIC EXTINGUISHER BY TURNING THE
WICK ADJUSTER KNOB TO ITS MAXIMUM POSITION
AND
COUNTERCLOCKWISE.
Wick height on position (1) of the wick height lock
should be 8 mm when wick adjuster knob is turned fully
1 1 1 1 c c
clockwise. Be sure to check.
NOTE: Remember always to start a new wick on
position (1) of the wick height lock.
NOTE: If the wick does not move smoothly and easily, or
wick height on position (1) of the wick height lock is
not in the range of 7-8 mm, do not use the heater.
Disassemble and repeat items 5 through 10.
NOTE: If any ragged edges appear on the top of the
wick, trim them with a scissors carefully. DO NOT cut
the body of the wick.
11 Replace the heater cover on the fuel tank and secure it
into position with three (3) thumbscrews. Replace
batteries in the battery holder. Be sure that the
combustion chamber is properly seated by moving the
combustion chamber handle left and right.
Once again, check the proper operation of the
automatic extinguisher.
NOTE: Before lighting a new wick for the first time,
turn the wick to its lowest position and allow the wick
to saturate with paraffin for about thirty (30) minutes.
THEN TURNING THE SAFETY BUTTON
4
61