Zibro Kamin KRA 106 Manuel D'utilisation page 61

1 1
2 2 b b
4 4
6 6
8 8 a a
8mm
4
60
REPLACING THE WICK
M
ENSURE THAT THE HEATER IS OFF AND COMPLETELY
COOLED BEFORE STARTING TO REPLACE THE WICK.
1 Release the automatic extinguisher by turning the
2 2 a a
safety button counterclockwise.
2 Remove the three (3) thumbscrews holding heater
cover, and lift cover up. Remove batteries from the
battery holder.
3 Remove the four (4) wing nuts around the wick
3 3
adjuster. Lift the wick adjuster off the heater while
moving it slightly back and forth.
4 Slide two fingers between the orange band on the wick
and the wick adjuster. After lifting all three (3) pins off
the slots, fold the wick and remove it.
5 5
5 Place the wick adjuster on its side. Next, line up the
three (3) openings in the wick adjuster: 1) the holes in
the sleeve, 2) the diagonal slots in the fixed part of the
wick adjuster, and 3) the slots in the moving part of the
wick adjuster controlled by the wick adjuster knob.
6 Fold the new wick in quarters and insert it into the wick
7 7
adjuster from wick adjuster bottom. Place one of the
pins in one of the line-up openings. If you experience
difficulty, gently turn the wick adjuster knob clockwise.
Then insert the two other pins, turning the wick
adjuster knob if necessary. Ensure that the wick holder
does not bend!
8 8 b b
7 Finally,
circumference, against the adjuster to insure that it is
firmly in place.
8 Lower the wick adjuster into the fuel tank, guiding the
tail of the wick so it fits over the primary air tube and
evenly into place.
Point the wick adjuster knob to the front of the heater.
Insure that the wick adjuster is centered over the studs
on the fuel tank.
NOTE: The space between the wick adjuster and the
primary air tube should be even all around.
gently press the wick, all along its