oneConcept 10029960 Mode D'emploi page 25

Distance between transmitters and receiver
High shielding materials between the units
(thick walls, steel, concrete, isolating alumi-
Interference from other sources (e.g. wirel-
ess radio, headset, speaker, etc. operating
No reception after adding extension cables
Poor contrast LCD or no reception or low
batteries in sensors or receiver
Temperature, humidity, or air pressure is
Trouble Shooting
Problem & cause Remedy
too long
num foil and etc.)
on the same frequency)
incorrect.
Reduce distance between transmitters and
receiver to receive signal
Find a different location for sensors and/or
receiver. See also item 'transmission range'
below
Find a different location for the sensors and/
or base station. Neighbors using electri-
cal devices operation on the same signal
frequency can also cause interference with
reception
Find a new location for the sensors and/or
base station.
Change batteries
Check/replace batteries. If multiple remote
sensors are in use, check location with cor-
responding "boxed numbers". Or move away
from sources of heat/cold. Adjust relative air
pressure to a value from a reliable source
(TV radio, etc.).
25