Klarstein New Breeze ECO Mode D'emploi page 42

EN
Cleaning the Heat Discharge Pipe
Remove the heat discharge pipe from air conditioner, clean and dry it , and then
reinstall it. (For the method of installation and removal , please refer to the instruction for
„Installation and disassembly of heat discharge pipe").
Checking before Use-Season
• Check whether air inlets and air outlets are blocked.
• Check whether plug and socket are in good condition.
• Check whether filter is clean.
• Check whether batteries are installed in remote controller.
• Check whether joint, window bracket and heat discharge pipe are installed tightly.
• Check whether heat discharge pipe is damaged.
Checking after Use Season
• Disconnect power supply. Clean filter and outer case.
• Remove dust and sundries on the air conditioner.
• Eliminate accumulated water in chassis (refer to the section of „Drainage way" for
details).
• Check whether window bracket is damaged or not. If yes, please contact dealer.
Long-time Storage
If you don't use the air conditioner for a long time, make sure there's no accumulated
water in chassis. Pull out the plug and wrap the power cord. Clean the air conditioner
and pack it well to prevent dust.
42