Publicité
Les langues disponibles
Les langues disponibles
HANDLEBAR ASSEMBLY
Remove the cable ties using a wire cutter.
Install the handlebar. Mount the handlebar to
2.2.1
2.2.2
Remove the stem screws and put them aside
the stem.
(T25 Torx).
Make sure that the clamp gaps under the low-
2.2.4
er stem bolts are even, and that the handlebar
is correctly centered and aligned in the stem
– there are markings to assist you with this.
Torque all bolts precisely to the spec indicated
by the stem and/or handlebar manufacturer.
1 0 y t
E1 3 B A S E
Start with the uppermost bolts, torqueing
2.2.3
down the top part of the stem clamps ac-
cording to the manufacturer's specifications.
Take care not to leave a gap here (zero gap).
Only then should you secure the handlebar
with the lower bolts as well.
P l ea s e f o l l o w t h e
t o r q u e s pec if ic at io n s o f
t h e ma n u fac t u re r s :
E13 Base:
Steerer tube screws //
Handlebar clamp screws //
Make sure the bike is standing safely on the
3.1
rear axle stand.
5 – 7 Nm
5 – 7 Nm
Use a torque wrench to tighten the derailleur
3.4
bolt. Make sure that the derailleur tab sits
against the corresponding tab on the derail-
leur hanger. Hold the derailleur in place with
your second hand to avoid it rotating out of
position and leaving a gap between the tabs.
REAR DERAILLEUR ASSEMBLY
Turn the rear axle stand on its side. Carefully
Screw the derailleur bolt in, but do not tighten
3.2
3.3
cut the cable tie using a wire cutter. Remove
it yet in order to be able to align the derailleur
the bubble wrap and the foam transport
properly in the next step (5 mm Allen key).
protection from the chainstay.
P l ea se f ol l ow t h e
t o rq u e sp e c i fi c at i on s of
t h e m a n u fac t u rer s:
Rear derailleur screw //
11 Nm
y t 1 1
Publicité
