Axis P13-E Serie Mode D'emploi page 23

2
Screw T20 (4x)
3 Wall bracket
4
Bracket adjustment screw T30
Connect the Camera
1. If applicable, connect external/input devices or audio devices to the camera.
2. Connect the heater cable to the heater connector in the bottom cover.
3. If using an SD card for local storage, insert the card into the camera's SD card slot.
4. Connect the housing to the network (PoE IN) and the camera to the housing (PoE OUT).
1
Network connector (PoE OUT)
2
Network connector (PoE IN)
5. Make sure that the camera and housing LEDs indicate the correct condition. See LED
Indicators on page 13.
6. Loosen the bracket adjustment screw to aim the camera to the point of interest. For
information about how to view the video stream, see Access the Product on page 24
7. Remove the plastic wrapper from the desiccant bag and put the desiccant bag below
the lens.
AXIS P13-E Series
23