Axis P13-E Serie Mode D'emploi page 21

1
Bottom cover
2
Bottom cover screw T20 (4x)
3
Cable gasket M20 (2x)
4
Tab
3. Push the network cable through the cable gasket.
NO TICE TICE
NO NO TICE
If the network cable has a premounted network connector, remove the cable gasket and
use the connector guard to prevent tearing of the cable gasket. Avoid using network
cables with capped network connectors because they could cause tearing of the cable
gasket despite using the connector guard.
4. Pull the network cable back slightly so that the cable gasket adjusts itself on the cable.
NO TICE TICE
NO NO TICE
Not pulling the cable back could cause water to seep in and damage the product.
AXIS P13-E Series
21