Windows Nt Quick Installation - Linksys EtherFast Serie Installation Rapide

8. If Windows asks you to supply any drivers beginning with "lne" or "netlne",
make sure the Linksys Setup Utility CD is in the CD-ROM drive and re-
direct Windows to your CD-ROM drive (D:\Drivers\WINME, where "D"
represents your CD-ROM drive).
9. Windows will finish installing the software onto your PC. Click Finish.
10. When asked if you want to restart your PC, remove the CD-ROM from your
PC and click Yes. If Windows does not prompt you to restart, do so man-
ually. Click the Start button, then click Shutdown, and choose the Restart
option and click OK.
Your Etherfast
has been installed successfully.
12
Instant EtherFast ®
® 10/100 LAN Card
Series 10/100 LAN Card

Windows NT Quick Installation

The following steps are for NT PCs that have networking already installed
according to the Windows NT documentation. If you have not already installed
networking onto your NT PC, please refer to your Windows documentation.
These steps will install the EtherFast
enabling your PC to properly communicate with the card. Remember that you
must be logged on as a network administrator to continue.
1. Click on Start, Settings, Control Panel, then double-click on the Network
icon.
2. When the networking window appears, choose the Adapters tab. Click Add.
® Card's driver software on your PC,
13