Windows Millennium Quick Installation - Linksys EtherFast Serie Installation Rapide

Windows ME Quick Installation
1. Start up your PC in Windows Millennium.
2. Windows ME will automatically detect the presence of the PCI Ethernet
Controller hardware in your PC.
3. Insert the "Linksys LNE100TX (ver. 5) Fast Ethernet Adapter Drivers" CD
into your CD-ROM drive while the Add New Hardware Wizard (in English)
window is visible. Click Next.
4. Select "Specify the location of the driver (Advanced)" and click Next.
10
Instant EtherFast ® Series
Note: Do not click Cancel or Skip at
any time during the installation.
Doing so will prevent the driver
from being properly installed on
your PC.
10/100 LAN Card
5. Select "Search for the best driver for your device (Recommended)" and select
"Specify a location". Then, type "D:\Drivers\WINME" in the drop-down
box and click Next.
6. A window will open, notifying you that Windows is searching for the Linksys
LNE100TX Fast Ethernet Adapter driver. When the window notifies you that
it is ready to install the driver, click Next.
7. Windows Millennium will begin copying the EtherFast
onto your PC. Have your Windows Millennium CD available. If an "Insert
Disk" box appears requesting Windows Millennium files, click OK and
direct Windows to the proper location of the files, e.g., D:\win9x (insert the
Windows CD into your CD-ROM if directing Windows to your Windows
CD) or c:\windows\options\cabs.
® Card's driver files
11