Windows 2000 Quick Installation - Linksys EtherFast Serie Installation Rapide

10. Remove your Driver Disk and CD-ROM and click Yes to restart your PC.
11. Once your PC has rebooted, double-click the Network Neighborhood icon
on your desktop. Make sure that you have access to the network. If you do,
your card has been properly installed.
• If you had previously installed any NT service packs, you must re-install
them. Otherwise, you may receive Not Enough Service Storage Space
errors in the Event Viewer.
• If you need to install the TCP/IP protocol, refer to your system administra-
tor or your Windows NT documentation. Linksys does not provide techni-
cal support for the configuration or troubleshooting of the TCP/IP proto-
col.
The Windows NT Installation and Setup of the EtherFast
10/100 LAN Card is complete.
16
Instant EtherFast ® Series
®
10/100 LAN Card

Windows 2000 Quick Installation

1. Start your Windows 2000 PC.
2. Windows will display the Found New Hardware Wizard (in English) box.
Click Next.
3. The Install Hardware Device Drivers dialog box will appear. When
Ethernet Controller is displayed, select "Search for a suitable driver for my
device (Recommended). " Click Next.
Note: Do not click Cancel or Skip at
any time during the installation.
Doing so will prevent the driver
from being properly installed on
your PC.
17