Operation - Mr. Heater MH11BFLEX Instructions D'utilisation Et Manuel Du Propriétaire

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
HEATER LIGHTING /
OPERATING INSTRUCTIONS
FOR USE WITH DISPOSABLE 1
LB. PROPANE CYLINDERS:
ALWAYS ATTACH OR DETACH
CYLINDER OUTDOORS AWAY FROM
FLAMES, OTHER IGNITION SOURCES,
AND ONLY WHEN HEATER IS COOL
TO TOUCH. NEVER SMOKE WHEN
ATTACHING OR REMOVING PROPANE
CYLINDER OR MAKING REMOTE
CONNECTIONS!
• Use only 16.4 oz. (1 lb.) disposable
cylinders that mate with No. 600 valve
connection.
• Heater and attached cylinder must
be in an upright position during

operation.

IMPORTANT: The heater must not be
exposed to flammable vapors or liquids
during lighting.
1. Make sure control knob is in "OFF"
position. See Figure 1.
2. Swivel regulator at the rear of
the heater outward for easy tank
installation. Screw 1 lb. disposable
LP-gas supply cylinder clockwise (from
bottom) into portable heater until
hand-tight. See Figure 2. Do not use
thread sealant on this connection.
3. Check cylinder connection for leaks
with soapy water at the threaded
connection under the domed plastic
cover where the cylinder screws into
the regulator. DO NOT USE ANY
EXPOSED FLAME TO CHECK FOR
LEAKS. DO NOT OVERTIGHTEN. SEE
WARNING! ON DOMED PLASTIC
COVER.
4. Push control knob down slightly and
rotate counterclockwise to Heater
"Ignition/PILOT" position. See Figure 3.
5. Push and hold control knob down
while holding down ignition button
until pilot is lit. See Figure 4.
6. Release ignition button and continue
to hold down control knob down for
30-60 seconds and release. (If pilot
does not sustain flame, return to
step #4.
7. With pilot lit, push control knob down
and rotate to LO/HI setting position.
Shutdown Instructions
1. To shut off heater, slightly push down
and turn Control Knob clockwise to
"OFF" position.
• Do not operate, store or remove
cylinder near flammable items or
ignition sources.
LP-GAS CYLINDERS MUST BE
DISCONNECTED FROM HEATER WHEN
NOT IN USE!
HEATER LIGHTING /
OPERATING INSTRUCTIONS
FOR USE WITH HOSE
CONNECTED TO A REMOTE
CYLINDER, MAXIMUM SIZE 20
LBS:
• This Heater may be used with a
remote refillable propane cylinder
ONLY when the cylinder is located
outdoors and the Heater is used
with Mr. Heater Hose No. F273701,
F273702 or F272702 and fuel
filter F273699. Fuel filter must be
replaced annually. (NOTE: Do not
operate without the fuel filter as
fuel contamination may damage the
heater.) Or use F273704 Buddy series
hose. Fuel filter not required.
• Inspect the hose before each use
of the heater. If there is excessive
abrasion or wear, or the hose is cut,
replace prior to using the heater with
one of the Mr. Heater Hose No's.
shown above.
• The propane cylinder must include a
listed overfilling protection device as
well as a collar to protect the cylinder
valve.
• Heater must be in an upright position
during operation.
IMPORTANT: The heater must not be
exposed to flammable vapors or liquids
during lighting.
1. Make the control knob is in "OFF"
position. See Figure 1 on previous
page.
2. Swivel regulator outward for easy hose
installation. Screw hose connector
into regulator on heater and screw
connector on other end of hose into
LP-gas supply cylinder valve. Tighten all
hose connections. DO NOT use thread
sealant on any of these connections.
Mr. Heater | Portable Buddy Radiant Heater
Ignition Button
5
Operating Instructions and Owner's Manual
Ignition
Pilot
LO ACC
ON
HI
Figure 3
Figure 4
Acc
Ignition
Pilot