Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION ON THE WALL
IMPORTANT!
PLACE THE BRACKET IN THE
CORRECT PLACE
2.
Slacken the 2 screws of the support jig (pic.2) and remove
it from the back part of the module. Fix it on the wall with nr. 2
screw anchors (12 mm not supplied) as indicated in the ref.2
3.
Hook-up the module to the screws. Hook th module up to
the screws of the suppoort jig (see slot on the back) using
the lateral guide as indicated in the picture 3a.
Slide down the module until the complete insertion of the
screws in the slot (pic.3a).
4.
Screwing the screws as indicated in the picture 4.
Assembling instrunctions and maintenance
2
SCREW ANCHORS NOT
3a
4
2a
SUPPLIED
24
Publicité
Table des Matières
