Adjustments - Ryobi CSB124 Manuel D'utilisation

Double insulated
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious injury.
0° BEVEL STOP
See Figure 23, page 19.
The saw has a 0° bevel stop that has been factory adjusted
to assure 0° angle of the saw blade when making 90° cuts.
To check 0° bevel stop:
 Unplug the saw.
 Place the saw in an upside down position on a workbench.
 Check the squareness of the saw blade plate to the base
of the saw using a combination square.
To adjust 0° bevel stop:
 Unplug the circular saw.
 Loosen bevel lock knob.
 Loosen hex nut securing adjusting screw.
 Turn adjusting screw and adjust base until square with
saw blade.
 Tighten hex nut and bevel lock knob securely.
WARNING:
Attempting a bevel cut without having the bevel lock knob
securely tightened can result in serious injury.

ADJUSTMENTS

ADJUSTING THE DEPTH LOCK LEVER
See Figure 24, page 19.
Over time, due to wear, the depth lock lever may move from
its original setting. If the lever prematurely contacts any part
of the saw during tightening and loosening, adjust the lever
by following these steps:
 Unplug the saw.
 Pull depth lock lever upward to release.
 Pull saw base down to the minimum depth of cut position,
then push the depth lock lever down to secure.
 Insert a flathead screwdriver into the space between the
lock nut and the E-ring. Remove the E-ring.
 Note the position of the lever on the nut. Slide the depth
lock lever off the lock nut.
 The lock nut has six flat sides. Rotate the depth lock lever
one "flat" counter clockwise around the nut. Then slide it
back into place.
 Push the E-ring back into the groove on the lock nut until
it snaps into place. Take care that the E-ring does not pop
off the lock nut.
 Loosen the depth lock lever and return the base to the
full depth of cut position and lock the depth setting by
pushing downward on the depth lock lever. The base
should be locked securely in position when locked and
be free to move when released.
14 - English

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Csb124g

Table des Matières