NRGkick 12501001 Manuel D'instruction page 17

Use the device in a way that the charging unit is hanging from the power grid socket. In this
condition water can flow off the charging device. Protect it from water intrusion!
If adapter plugs are used, never adjust a higher charging current than
1) the maximum current, which the adapter is certificated for.
2) the maximum current, which the upstream installation and the socket are approved for.
If the power supply socket feels hot during charging, replace this socket immediately!
Do not pull at the cable ends of the charging device by force!
The use as a rope for lifting or pulling mechanical loads as well as for wrapping or tying up objects
is strictly prohibited!
The charging device may only be operated for its intended use!
Pull the cable from the socket at the connector only. Never pull at the cable!
Protect the charging unit and the charging cable from mechanical damage (run over by tyre,
pinching or kinking) and the electrical contact area from heat sources, dirt and water!
Only use adapters and accessories, which were supplied by DiniTech GmbH together the charging
device or which were approved by DiniTech GmbH!
EN
In the following countries it is not permitted to adjust a higher charging current than 8A if a
Schuko adapter plug is used:
Denmark, Finland, France and Switzerland
If a Schuko adapter plug is used, the weight of the charging unit must not overload the socket. Take
care to relief the cable (e.g. by supporting the device or by deflection of the cable via a hook).
Ver.:1512-03 4