Fisher&Paykel DCS DishDrawer DD24 Serie Guide D'utilisation page 26

Troubleshooting
22
US
CA
Problem
The wash program
seems to have
finished (the
dishwasher is idle),
but the end of
wash beeps haven't
sounded and the
drawer cannot be
opened
Water pooling on
inner rim of drawer
after a wash
Water under the
drain filter
Excess water in the
drawer
Water marks on the
dishes
Drawer interior is
stained
Dishes did not dry
No detergent
dispensed
Excessive motor
noise
Possible Cause
The wash program is still
underway. It is in a 'quiet'
phase that is needed for
ensuring the best wash
results.
This is normal condensation. If there is any water over the control buttons,
This is normal and needs no action.
Drain hose(s) bent or
kinked.
Blocked filters.
Rinse aid depleted.
Rinse aid setting too low.
Dishwasher overloaded/
incorrectly loaded.
Some foods, like tomato
based products, may stain
the inside of the drawer.
Incorrect loading.
Dishes were left in the
drawer for several hours
after a wash.
Rinse aid depleted.
Rinse aid setting too low.
Eco wash program used.
Detergent dispenser was
wet when loaded.
The filter plate and/or spray
arm is incorrectly placed.
No water in the motor area.
What to do
No action required. The program will
transition into a more audible phase after the
'quiet' phase is over.
wipe dry.
Straighten the drain hose(s).
Clean the filter plate/drain filter. Refer to
'User maintenance instructions' .
Refill the rinse aid dispenser.
Increase the rinse aid setting.
Refer to the section on loading.
Pre-rinse dishes before placing in the drawer.
Alternatively, using the Rinse program after
adding the dishes may minimise staining.
Ensure the dishes are not nesting together.
We recommend unloading the dishes within
a few hours after a wash program has
finished, as the small amount of vapour left
after the wash may -with time- resettle on
dishes as condensation. Using rinse aid or
increasing its setting may also help reduce
this problem.
Refill the rinse aid dispenser.
Increase the rinse aid setting.
Choose a standard wash program.
Clean the dispenser and ensure it is dry
before adding detergent.
Refer to the 'User maintenance instructions'
section for details on correct placement.
This usually occurs on the first use or when
the dishwasher has not been used for long
periods of time. Pour 3 cups of water into
the drawer before running a wash program.