Fisher&Paykel DCS DishDrawer DD24 Serie Guide D'utilisation page 25

Problem
Drawer will not
open (no beeping,
no wash underway)
Power failure
during cycle
Continuous
beeping
Intermittent
beeping
High-pitched,
subtle beeping
during a wash
program
Control buttons
inside the drawer
do not respond to
touch
Dishwasher will not
start
Fan noise
coming from the
dishwasher after a
wash program has
finished
Fan noise starts
up when I close
the drawer, even
though I didn't start
a new wash
Possible cause
Childlock feature is on or
the 'Closed drawer autolock'
option is on, or both.
Power outage in your home
or area.
A fault has occurred.
Dishwasher is in pause
mode.
Rinse aid is being
dispensed.
Water over control buttons.
Power supply is not
connected.
The drawer is not closed
properly.
Keylock or Childlock feature
is on.
button not pressed.
This is normal. The drying
fan continues to run for a
set period of time after a
program has finished to
assist with drying.
This is normal. In some
cases, the drying fan will
run whenever the drawer is
closed for a set period of
time after a program has
finished.
Troubleshooting
What to do
Turn the Childlock off. Hold down the
button until the light above the
button goes out and/or press the
to open the drawer.
Wait until power resumes, cycle will restart in
same part of wash program.
Refer to section 'If there is a fault' .
Close the dishwasher and press the
button to resume the program.
This is normal and needs no action.
Wipe the area dry.
Connect the power supply.
Ensure the drawer is firmly closed.
Turn the Keylock or Childlock off. Hold down
the button until the light above the
button goes out.
Press the button.
No action required. The fan will automatically
stop after the set time is over, or when the
drawer is opened. In some cases, the fan may
resume when the drawer is closed again.
No action required. The fan will automatically
stop after the set time is over.
21
US
CA
button