Fisher&Paykel DCS DishDrawer DD24 Serie Guide D'utilisation page 22

User maintenance instructions
18
US
CA
Cleaning the spray arm and filter plate
To remove and clean the spray arm and filter plate
Unplug the dishwasher or turn it off at the power
1
supply.
Unclip the glass supports (if fitted) from the rack
2
wires and fold all the adjustable racks away, so
that they are upright and close to the top.
Remove the base rack carefully. Lift from the back
3
end first to prevent knocking the detergent and
rinse aid dispenser.
Lift the spray arm and shake any foreign material out.
4
Rinse it clean under running water and wipe with a damp cloth.
Lift and remove the drain filter.
5
In the centre of the filter plate there are two rings. Turn the outer ring anticlockwise, about a 1/8
6
turn. This will release the filter plate.
Lift the filter plate out. Remove any foreign material, wash in hot soapy water and rinse
7
thoroughly in clean water, then wipe with a damp cloth. Take care handling the sharp outer edge
of the filter plate.
4
6
Turn outer
ring 1/8 turn
2
3
5
7
1