Fisher&Paykel DCS DishDrawer DD24 Serie Guide D'utilisation page 23

To replace the filter plate and spray arm
Before replacing the filter
8
plate, ensure the O-ring is correctly
positioned on the base, as shown.
Orientate the filter plate and lower it into place:
9
make sure its kidney-shaped hole aligns with
the matching recess in the dishwasher base.
Ensure the filter plate lies flat in the base, then
10
lock it into position: turn the outer ring clockwise
until the the marks align with each other and all three pin pairs firmly interlock, as shown.
Important!
The filter plate must not be able to move about freely.
Replace the drain filter, ensuring it is flush with the filter plate.
11
Replace the spray arm back onto the impeller.
12
11
Replace the base rack, lowering its front edge into position first.
13
Plug the dishwasher back in or turn it on at the power supply.
14
Note: Where there is broken crockery or glass in the drawer, it must be carefully removed to
prevent damage to the dishwasher.
User maintenance instructions
O-ring
Alignment marks
9
19
US
CA
10
Inter-
locking
pin
Outer ring
12