BEHAbelt RS02 Consignes D'installation Et Mode D'emploi page 25

Between the two ends profile now should still minimal welding gap (light gap).
Warning: It is not necessary to tighten the tension bolts to the full stop point when
fastening belts in the RS02 welder. Only tighten the tension bolts as required to
prevent belt slippage in the jaws. Over tightening can cause damage to the tension
bolts and cause the material to deflect.
STOP
Note for the welding of small profiles: Clamp profile in the fixed clamping jaw with
only 2 mm supernatant Clamp other end of the profile in the oscillating jaw with
only 3 mm supernatant. Do not crush profile so that a planar friction surface as
possible is preserved.
Set the contact pressure on adjustment knob (7).
Heavily depressed position -> full pressure.
slightly depressed position -> half pressure.
General:
large profiles from Ø 12 -> Full set pressure (7)
small profiles < Ø 12 -> Half set pressure (7)
Switch on the machine (2) Important: only with clamped profile, risk of voiding
parts (profile jaws)!
After reaching the max. speed of the motor by pressing the release button (6) fusion
process (welding jaws move together).
When profile swells up, switch off the machine (2).
Welding process is finished.
Leave profile clamped for 2-3 min. in the machine to cool off.
Note: Allow to cool profile after removal for about another 10 minutes before the
weld is loaded.
First, open the hex head bolt (10) to take out the profiles. Then move apart with the
external hex (4) the sealing jaws to facilitate the removal of the profile.
Now the next welding process can be performed.
25