Notes On These Operating Instructions; Safety Pictograms And Symbols; Operation - Endress+Hauser iTEMP HART Communication TMT 182 Manuel De Mise En Service

1 Notes on these Operating Instructions

Safety pictograms and
symbols
24
1 Notes on these Operating Instructions
These communication Operating Instructions are a supplement to the Operating
Instructions which help to configure iTEMP
communication protocol easily and quickly. Devices that can be configured with the
support of these instructions are listed in the appendix of these Operating Instructions.
CE mark, Declaration of conformity
Devices that are configured with the support of these instructions are built and tested to
the state-of-the-art and are operationally safe. They have left the factory in perfect
condition as regards technical safety. The unit has been manufactured using up-to-date
production equipment and has left our works in perfect and safe condition. The units
comply with the safety requirements to EN 61 010.
The units described in these instructions therefore fulfils the legal requirements set by
the EU guidelines. The manufacturer confirms a positive completion of all tests by fitting
the unit with a CE mark.
1.1

Safety pictograms and symbols

In these instructions, particular operating procedures are highlighted with safety icons,
which are allocated the following symbols.
Attention!
This symbol indicates activities and actions that, if not followed correctly, could lead to
faulty unit operation or even damage to the unit.
Hint!
This symbol indicates activities and actions that, if not followed correctly, could have an
indirect influence on the unit operation or could lead to an unforeseen unit reaction.
2

Operation

The temperature head transmitter is set up using the HART
measured can also be read using the HART
two possibilities:
• Operation using a universal hand operating module "HART
DXR 275".
• Operation using a PC and operating software (e.g. Commuwin II, FieldCare or
®
ReadWin 2000) as well as a HART
iTEMP® HART® Communication
®
measuring devices operated via the HART
®
protocol. The values
®
protocol. In order to do this the user has
®
®
modem (e.g. "Commubox FXA 191").
®
Communicator
Endress+Hauser