First Start - FOGAL Alaska Mode D'emploi Original

PLEASE NOTE: if the cabinet has to be relocated, fix again the metal-
I
lic supports following the above mentioned instructions.
Fix the supplied spacers on the back of the cabinet as per the atta-
ched instructions.
Place the cabinet in its ultimate location and when the floor is not
properly flat, it can be stabilized by setting the four adjusting feet in
GB
order to guarantee a proper stability to the cabinet.
Please note that during the operations described in par. 6, the ope-
rator in charge must assure that no authorized people or no pro-
perly protected people respect the safety distance from the cabinet,
especially during the removal and the fixing of the metallic supports.
F
6a. Electrical connection
Be sure that the electrical system of the place where the cabinet has
to be installed complies with the regulations and the security codes
in force.
The power supply of the cabinet has to be independent from other
supplies and protected with a proper insulation.
D
It has also to be protected with obligatory earthing.
The maximum allowable system impedance is Zmax=0,049 W
Please check with the energy supply authority the maximum elec-
tricity grid impedance value. This value does not have to exceed the
maximum allowable system impedance.
NL
32
Please follow tension and frequency instructions shown on the la-
bel on the back of the cabinet.

7. FIRST START

To start an integral cabinet up is enough to connect the plug with
the socket.
The electronic display is set to guarantee a proper working based
on the class temperature of the cabinet.
Be sure that the temperature class complies with the products that
have to be kept in the cabinet (see catalogues and technical tables).
For any information please get in touch with the retailer. A wrong
about 6 cm
image > 5
33
I
GB
F
D
NL