Connecting Wires To Terminals - Kenwood DMX7018DABS Mode D'emploi

Connection/Installation
Ñ

Connecting wires to terminals

Light Blue/Yellow (Steering remote control wire)
To steering remote
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matched to your car.
Light Green (Parking sensor wire)
Accessory 4:Parking Extention cable
Connect to the vehicle's
parking brake detection
switch harness.
Purple/White (Reverse sensor wire)
Connect to vehicle's
reverse lamp harness
when using the
optional rear view
camera.
ISO Connector
USB maximum power supply current :
[1]
DC 5 V = 1.5 A
Sold separately
[2]
Optional accessory
[3]
50
For best safety, be sure to
connect the parking sensor.
M4x6
1 3 5 7
2 4 6 8
1 3 5 7
2 4 6 8
Connector B
Connector A
Fuse (15A)
REAR OUT
CAM IN
Connect to vehicle's steering remote
harness.
Contact your KENWOOD dealer for details.
STEERING
REMOTE
INPUT
USB terminal
5V = 1.5A
MIC
Subwoofer Preout
SUB
WOOFER
FM/AM antenna
REAR OUT FRONT OUT AV IN
L
R
ANT
CAM IN VIDEO OUT VIDEO IN
DAB antenna CX-DAB1
DMX7018DABS only.
!
CAUTION
Use of a CX-DAB1 (optional accessory)
as a DAB antenna is recommended.
When using a commercially available
DAB antenna, the diameter of the SMB
connector must be Φ6.5 mm or less.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
FRONT OUT AV IN
AV-IN audio input
(Left; White, Right; Red)
AV-IN visual input (Yellow)
VIDEO OUT VIDEO IN
Visual Output (Yellow)
Rear view camera input (Yellow)
(1 m)
[1]
USB device
Cap
Accessory 1
Bluetooth
Microphone
Cap
Φ 6.5 mm (maximum)
[3]
[2]