Controlling General Audio - Kenwood DMX7018DABS Mode D'emploi

Controlling Audio
Tweeter (Only for Front)
■
You can set the tweeter when you are
selecting front speakers.
None, Small, Medium, Large
X'over
■
Displays the speaker crossover setup screen.
You can adjust the crossover setup that was
set automatically when you selected the
speaker type.
For details, see Crossover network setup
(P.42)
Ñ
Crossover network setup
You can set a crossover frequency of speakers.
1
Touch [Xʼover].
2
Touch the speaker to set.
3
Set each item as follows.
HPF FREQ
■
High Pass Filter adjustment. (When front or
rear speaker is selected on Speaker Select
screen)
LPF FREQ
■
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope*
■ 1
Sets a crossover slope.
Gain
■
Adjusts the front speaker, rear speaker, or
subwoofer level.
42
TW (Tweeter) Gain *
■
Adjusts the tweeter level. (When front is
selected on Speaker Select screen)
Phase Inversion*
■
Sets the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When subwoofer is selected
on Speaker Select screen)
* Only when "LPF FREQ"/"HPF FREQ" is set to
1
a mode other than "Through" in [Xʼover].
* Only when "Tweeter" is set to "Small",
2
"Medium", "Large" in [Speaker Setup].
* Only when "Subwoofer" is set to a mode
3
other than "None" in [Speaker Setup].

Controlling General Audio

1
Press the [MENU] button.
h Popup menu appears. h
2
Touch [Audio].
h Audio screen appears. h
3
Touch [Fader / Balance].
4
Set each item as follows.
Fader / Balance
■
Adjust the volume balance around the
touched area.
[C] and [D] adjust the right and left volume
balance.
[R] and [S] adjust the front and rear volume
balance.
■
[Center]
Clear the adjustment.
2
3