Installation Procedure; Installing The Unit - Kenwood DMX7018DABS Mode D'emploi

Connection/Installation
Ñ
Supplied accessories for
installation
1
(3 m)
2
3
4
Parking Extention cable (2m)
5
Ñ

Installation procedure

1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the ISO connector to the unit.
4) Install the unit in your car.
5) Reconnect the ¤ terminal of the battery.
6) Perform the Initial Setup.
See Initial setup (P.6).
48

Installing the unit

x1
x2
Ñ
Trim plate
x1
1) Attach accessory 3 to the unit.
x1
x1
Ñ
Microphone unit
1) Check the installation position of the
microphone (accessory 1).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 1), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory 1) to the driver.
Fix a cable with a commercial item of tape.
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.
1
3