Assembly Instructions; Tools And Parts; Cabinet Use Requirements; Assemble Cabinet - Gladiator GAJG36FDYG Instructions D'assemblage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Tools and Parts

Gather the required tools and parts before starting installation.
Tools Needed:
1/2" Wrench
Phillips screwdriver
Tools Supplied:
Hex key

Cabinet Use Requirements

Intended for use in a garage.
Maximum weight limit is 50 lbs (22.7 kg) for each shelf.
Maximum weight limit is 300 lbs (136 kg) for the cabinet.
Unpack the Cabinet
1. Remove and verify the contents. Contents include a hex key, a
key, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.

ASSEMBLY INSTRUCTIONS

Level
Key

Assemble Cabinet

WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT: Two people may be required to complete the
assembly. As you assemble the cabinet, make sure the edges
with the holes are facing up. If you are assembling the cabinet on
the floor, fasten the eight front corner bolts, two at each corner,
after you stand the cabinet upright.
1.
Assemble Cabinet
F1
F1
F1 5/16" hex-head bolt (28)
F2 5/16" flange nut (12)
P1
P2
P2
Place side panel (P1) on a flat, firm surface so that the edge
with the holes is facing up, as shown. Insert the cabinet top (P2)
between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
Align the holes and attach the top (P2) to side panel (P1) using
hex-head bolts (F1) and the three 5/16" flange nuts (F2), as
shown. Do not tighten completely. Position the other side panel
(P1) so that the top (P2) is between the edges of side panel (P1).
Align the holes and attach the top (P2) to the side (P1) using
hexhead bolts (F1) and the three 5/16" flange nuts (F2), as shown.
Do not tighten completely. Insert the cabinet bottom (P3) between
the edges of the side panels (P1).
NOTE: Make sure the edges with the holes are facing up.
Align the holes and attach the bottom (P3) to the sides (P1) using
hex-head bolts (F1) and the three 5/16" flange nuts (F2). Do not
tighten completely.
F2
F2
P3
P1
P1
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gajg36fdzwGajg36fdksg

Table des Matières